其它技术要求:
OTHER SPECIFICATION REQUIREMENT
1、筒体、封头及其相互间对接焊全截面焊透。
The butt joints for shell,heads and others shall be full fusionwelding.
2、设备不锈钢表面需清除油污做酸洗钝化处理,对所形成的钝化膜进行蓝点法检查,无蓝点为合格。
THE EQUIPMENT SHOULD BE PICKLING&SUBLIMATE AFTER FABRICATION ON STAINLESS STELL.SUBLIMATE FILM HAVE BLUEPOINT METHOD TEST.
WITHOUT BLOEPOINT IS QUALIFIND.
3、设备碳钢部分外表面油漆以及包装、运输按JB/T4711-2003规定。
THE BEADED PAINT SUM OF THE AETIOPORPHYRIN FURNISHED THE BALE TRANSPORT CLICK JB/T4711-2003 SPECIFIED.
4、设备管口支座方位按俯视图。
THE ORIENTATION OF THE FURNISHED SEE PLAN VIEW.
5、进行液压试验时,应控制水中的氯离子含量不超过25mg/L,试验合格后应立即将水渍清除干净。
THE AFTER HYDRAOLICALLY TESTED,THE DROP OF WATER SHOLUD OFF OR THE CHIORIDE ION'S CONIENT IN WATER SHOULD BE CONTROLED LESS THAN 25mg/L.
6、与物料接触部份(内挡板的上沿至釜底)抛光300#。
7、夹套水压试验时,内筒需充压0.033Mpa。
